DECODER IRRIGATION

In the ground.
At the heart of the system.

Two-wire and three-wire decoder technology for golf courses, landscape irrigation and specialist installations — supported by decades of practical field experience.

FIELD TECHNOLOGY

The small component
doing an important job.

At each valve, a decoder receives commands from the controller over the field cable and switches the connected solenoid. The hardware may be modest, but the signalling, cable condition, surge protection and compatibility are fundamental to reliable operation.

Aquarille works with established TIC FieldSwitch decoder technology and controller interfaces. These are the practical foundations that inform the new TicWEB system.

FIELdSWITCH / TIC ELECTRONICS2-wire
3-wire

Multiple protocol families and controller generations.

DECODER FAMILIES

Compatibility
comes first.

The correct decoder depends on the controller and field signalling protocol. These are real product families documented by TIC Electronics — confirm the exact version before ordering.

01 / TWO-WIRE

Watermation / Aquarius

TIC FieldSwitch two-wire decoders for systems specifying Watermation, Aquarius or compatible Tonick signalling. Single, dual, triple and quad-output variants are listed by TIC.

Up to 127 addresses on Watermation-compatible systems
02 / TWO-WIRE

Landscape 63

Decoder family associated with the established Underhill Landscape protocol and compatible control systems. Suitable protocol choice is essential.

63-station family
03 / TWO-WIRE

Landscape Plus

Extends compatible Landscape installations to 127 addresses per cable path when used with the appropriate TIC controller, without replacing existing 63-station decoders.

127-station expansion capability
04 / THREE-WIRE

Toro / Bailoy / Trident

FieldSwitch three-wire decoder for Trident PC, SC1000/SC3000-family controllers and appropriately configured Aquarille/translator hardware.

Three-wire field cable systems
05 / SPECIAL APPLICATIONS

Custom protocols

TIC has documented custom decoder variants for OEM systems with differing signalling or protocol requirements. Compatibility must be established for each installation.

Discuss protocol requirements
06 / FIELD TOOL

Handheld programmer

TIC's battery-powered FieldSwitch programmer supports address programming and field testing of compatible two-wire decoders, without a separate inverter or vehicle battery.

Two AA cells · portable field operation
TYPICAL FIELD SWITCH ENCAPSULATED DECODER51 × 38 × 24 mmExcluding flying leads
APPROXIMATE MASS75 gTypical single decoder
SUPPORTED INPUT12–40 V ACRMS, pure sine, 45–65 Hz
OUTPUT500 mAMaximum, per TIC published specification
WHY SYSTEM DESIGN MATTERS

More than
a decoder in a box.

Good field reliability comes from the whole system: decoder design, controller signalling, cable quality, earthing and surge protection working together.

TIC documents resin-encapsulated decoder construction, robust surge-protection techniques and signal processing intended to tolerate challenging cable conditions. Proper grounding and controller configuration remain critical, especially where lightning protection is concerned.

For retrofits and mixed-generation sites, compatibility should be checked before any equipment is changed.

Talk about your field system ↗
TECHNICAL INFORMATION

The right decoder
for the right system.

Have details of the existing controller, decoder protocol, number of stations and cable arrangement to hand. We can help discuss the likely options.

Contact Aquarille ↗

Technical details summarised from TIC Electronics' published decoder information. TIC FieldSwitch is a TIC product family. These draft pages are not a substitute for current manufacturer specifications.